How to Change Kawasaki Vulcan 1700 Vaquero Oil

Regular oil changes keep your Kawasaki motorcycle running at its best. Keep up with standard maintenance and your bike will reward you with many years of memories of life on the road. 

Watch the video above and follow the steps below to do an oil change on a Kawasaki Vulcan Vaquero 1700.

Tools and Parts - Kawasaki Vulcan 1700 Oil Change

Buy Kawasaki 10W-40 motorcycle oil

Buy Kawasaki motorcycle oil filter

Changing the Oil on a Kawasaki Vaquero 1700 

Step 1. Run the engine for a minute or two to warm up the oil and make it easier to drain.  

Step 2. Turn off the engine and remove the oil fill cap to allow the oil to drain easier. 

Kawasaki Vulcan 1700 oil change

Step 3. Get a drain pan underneath the bike and remove the two drain bolts under the motorcycle with a 17mm socket to drain out the oil. 

Kawasaki Vulcan 1700 oil change drain bolts

Kawasaki Vulcan 1700 oil change service

Step 4. Replace the drain bolts by threading them into place and torqueing them both to 14 foot-pounds.

Kawasaki Vaquero 1700 oil change drain bolts

NOTE: Kawasaki recommends replacing the crush washers, which they call gaskets, on the bolts before reinstalling them.  

Kawasaki Vaquero 1700 oil change service

Step 5. Remove the oil filter (located on the front of the engine) with a 65mm oil filter wrench. 

Kawasaki Vulcan Vaquero oil change

NOTE: Keep a drain pan underneath the filter, since a fair amount of oil may come out.

Step 6. Smear oil around the gasket at the top of the new oil filter to make it easier to remove next time. Thread the new oil filter in and torque it to 13 foot-pounds. 

Kawasaki Vulcan 1700 oil filter

Kawasaki Vulcan 1700 oil filter change

Step 7. Pour in about 4 quarts of Kawasaki 10W40 oil.  

Kawasaki Vulcan 1700 Vaquero oil change refill

NOTE: We used Kawasaki’s full synthetic 10W40 motorcycle oil, but you can use regular 10W40 motorcycle oil as well.

Step 8. Replace the fill cap and run the engine for a couple of minutes to circulate the oil. Don’t throttle the engine, just let it idle. Next, shut the engine off and wait a couple of minutes for the oil to settle so you can get an accurate oil reading. 

Step 9. Check the oil, then remove the fill cap and dipstick and wipe it dry. Replace the cap and thread it in, then remove it again to get a level reading.

Kawasaki Vulcan motorcycle oil change

The Kawasaki Vulcan 1700 takes about 4 ½ quarts of oil. If the motorcycle's oil level is low at 4 quarts, top it off with the extra half-quart, then check the oil level again and you’re done. 

Kawasaki Vulcan 1700 Vaquero oil change

Ready to change out the air filter next? Watch the video below to see how to replace the air filter in a Kawasaki Vulcan 1700 Vaquero

 

body

Why Partzilla?

Commercial Discounts

Special discounts for companies in the powersports industry

Details

Government Sales

Discounts for federal and most state and municipal agencies

Details